Mirage Harness Sizing

The Mirage harness has four (4) parts.

1. MLW : The main lift web is the front of the harness and is determined by the length of your torso.
2. LP : The leg pads.
3. STAB : The stabilizers (waist) determine how snug the bottom of the rig is against your back.
4. YOKE : This is over the shoulders.  If you have a large chest or thick shoulders (lift weights) you may need a longer yoke.

Our stock rigs already have a stabilizer and yoke size.

Instructions:  

A

Determine Your Stabilizer (waist) :

Measure around your waist at the belly button

●  The stabilizers determine how tight the rig is against your lower back.

●  Stabilizers are sized in 1/2 inch (1.27 cm) increments

●  + or – 1/2 inch from your size is usually acceptable.  Each increment is similar to loosening or tightening your belt one notch.

●  More than 1/2 inch from your correct size is not desirable.  The rig will be too tight or too loose against your back.

Reference Tool : Stabilizer Measurement

B

Determine Your Yoke (chest/shoulders) :

Measure around your chest across the nipples

●  If a yoke size isn’t indicated then the rig has a standard yoke

●  +1 or -1 yoke means that the distance from the top of the rig to the 3 rings (over the shoulder) was adjusted by 1 inch.

●  A standard yoke is usually acceptable for a person that needs a -1 yoke.

●  A standard yoke will feel snug or tight in the shoulders for a person that needs a +1 yoke

●  If you have thick shoulders (lift weights) you may want us to double check your sizing.

Reference Tool : Yoke Measurement

C

Filter For Your Stabilizer & Yoke Size To See The Stock Rigs That Can Fit You !

Remember that you can usually go up or down one stabilizer size if desired